39
RECHARGING BATTERIES
1
2 3 4
5
12
13
14
15
Pb 1PB ST 36V/45A
---V ---A
Ah=-- Tc:-- --
CHARGE
6
7
8
9
10
11
WARNING! THE CHARGER IS PRESET FOR LEAD BATTERIES. TO MOUNT GEL OR AGM BATTERIES,
BOTH THE STATUS LED AND THE CHARGER HAVE TO BE SET ACCORDING TO THE TYPE OF
BATTERY WHICH IS TO BE USED. TO THIS AIM, PLEASE CONTACT EITHER A TECHNICIAN OR AN
AUTHORIZED RETAILER.
To charge the batteries follow the instructions below
:
Bring the machine into a stop position in a flat surface area, turn it off and put on the brake
;
Before charging the battery make sure to scrupulously follow the battery charger instruction manual provided
with the machine
.
The recharging of the battery is to take place in well-aired environments.
Open the hood of the seat pos.14 by releasing the locking device pos.15;
The battery charger can run with a voltage range 230 VAC, for the use with different voltages it is advisable to use a
proper charger.
Unwind the cable from the cable reel pos.12 located on board the machine and connect the plug pos.13 into a standard
electrical power socket. After fitting in the socket, the battery-charger display screen will light up and, after completion of a
start sequence, a series of parameters will be displayed including the type of battery and the set charge curve (pos.10), the
size of the battery charger (pos.9), the recharge voltage (pos.11), the recharge amperage pos.8, charged amps (pos.1),
recharge time (pos.7).
The word CHARGE will appear (pos.6) combined with the flashing of the green LED (pos. 2) to indicate that the charge
phase is being correctly performed. If the word NO BAT appears in pos.6, this means the battery connector is disconnected.
Connect the battery connector and start the charge cycle again.
The LEDs 2-3-4 indicate recharge progression. At the end of recharge, all 3 will be on.
WARNING: WHEN PLUGGING THE BATTERY CHARGER INTO THE ELECTRICAL SOCKET, THE
MACHINE FUNCTIONS ARE AUTOMATICALLY DISABLED
.
Once the charge is completed the plug can be disconnected from the electrical socket and rolled back into the cable reel
Once the battery is charged make sure to check the electrolyte level and if necessary fill it up only using distilled
water.
The gas released during the charging process can cause explosions if it comes into contact with flames or sparks.
Battery acid should never come into contact with the eyes, skin or clothes, make sure to wear goggles, gloves and
appropriate clothing.
If it comes into contact with the eyes or skin, wash immediately with abundant water.
Do not place metal objects on the batteries.
Do not fill the batteries with sulphuric acid or other products.
