18
ENGAGING AND RELEASING THE BRUSHES OR THE ABRASIVE
DISCS
CHEMICAL
1.5%
2%
3%
4%
1%
ON/OFF
1
4
2
3
6
8
9
5
7
Follow the instructions below to engage the brushes or disc pad holder with abrasive disc:
Make sure there is water in the solution tank;
Turn off the machine and press the key (pos.4) into position 0.
Position the brushes or the discs (pos. 9) under the brush plate (pos. 8) lifting the splashguard (pos. 7).
Turn the key (pos.4) into pos. 1 and wait till the ignition sequence is over and the battery charge level is visible on the
display
Lower the brush plate (pos. 8) by pressing the brush button on the control panel (pos.3)
Slowly push forward the drive control (pos.6). The brush motors will start rotating and the machine will start to move
slowly. Go forward for a brief distance and then go in reverse drive using the switch (position 5) and step back slowly
until engaging the brushes. Repeat the operation if necessary. To prevent leaked waste during the operation, it is
advisable to set the detergent solution flow to 0 (all led lights in position 1 are off).
Follow the instructions below to release the brushes or disc pad holder with abrasive disc:
Stop the machine on a flat piece of floor;
Lift the brush plate and press the brush button to deactivate the brush function pos.3.
Press the brush release button on the keyboard pos. 5. The releasing sequence will be activated and the brush will be
released from the plate.
