33
ROTATING OR REPLACING THE SPLASHGUARD BLADES
Follow the instructions below to rotate or replace the splashguard side or front blade:
Turn off the brushes function and lift the brush plate;
Turn off the machine, remove the key and the battery connector and put on the brake.
1
2
3 4
5
6
7
ROTATING OR REPLACING THE FRONT
BLADE
Use a 10mm hex wrench (position 7) and
remove the 10 screws (position 6) and the
respective washers;
Remove the rubber locking plate (position
5);
Remove the rubber (position 4) and
replace it;
Put everything back into place;
ROTATING OR REPLACING THE SIDE RIGHT BLADE
Use a 10mm hex wrench (position 7) and remove the 7 screws (position 1) and the respective washers;
Remove the internal rubber locking plate (position 3);
Remove the right side blade (position 2), rotate it 180° and put it back into place if the external edge is in good
condition, otherwise replace it with a new one;
Put the rubber and the internal plate back into place using the 7 screws (position 1) and the respective washers making
sure that the rubber is equally distributed over the entire length.
1
2
3
4
ROTATING OR REPLACING THE SIDE LEFT BLADE
Use a 10mm hex wrench (position 4) and remove the 7 screws (position 3) and the respective washers;
Remove the internal rubber locking plate (position 1);
Remove the right side blade (position 2), rotate it 180° and put it back into place if the external edge is in good
condition, otherwise replace it with a new one;
Put the rubber and the internal plate back into place using the 7 screws (position 3) and the respective washers making
sure that the rubber is equally distributed over the entire length.
