24
LIFTING THE SPLASHGUARD FOR THE PRE-WASHING
1
2
2
2
2
A pre-washing operation is highly advisable when using the machine for particularly dirty surfaces, as to allow the
chemical product present in the detergent solution to remove the dirt more efficiently.
Once pre-washing is over, clean the surface by activating the brush function. Do not use the squeegee to gather the
solution. During this operation it is advisable to lift the machine splashguard as to allow the detergent solution to spread
smoothly over the surface.
After a few minutes, wash the surface one more time after lowering the splashguard and activating the vacuum function as
to dry the floor.
To lift the splashguard, please refer to the following instructions:
Lift the splashguard (pos. 1) manually by pulling it upwards;
Make the 4 blocking lever pos. 2 rotate. This way, the splashguard will remain raised from the ground.
Once pre-washing is over, unfasten the screws pos. 2 thus letting the splashguard pos. 1 lower.
MOUNTING THE ABRASIVE DISC ONTO THE DISC PAD HOLDER
The machine can operate with brushes or abrasive discs of various types mounted on special disc pad holders.
Follow the instructions below to mount the abrasive disc onto the disc pad holder:
Remove the disc lock (position 3) from the disc pad holder (position 1) by pressing the 2 ends of the spring catch
(position 4) against each other.
Position the abrasive disc (position 2) and centre it onto the disc pad holder (position 1).
Place the disc lock (position 3) on the centre and press down hard until the spring fits into place (position 4); this
operation can be carried out using the palm of your hand, or your foot if the disc pad holder is resting on the ground.
