All rights reserved. Reproduction as well as electronic duplication of this guide, complete or in part, requires the written consent of ESERA-
Automation or E-Service GmbH. Errors and technical modification subject to change.
©
ESERA-Automation, E-Service GmbH 2019
www.esera.de
Programming Manual Controller-Gateway-Station V1.0 R1.1
Page 69 of 77
22.4.1. Set One Wire Device Command, group commands
With the group command, a large number of actuators can perform the same function without having to send a
single command to each individual 1-Wire device.
1
2
3
4
5
Description
SET
OWD
GRP
steering
command,
e.g. SHT
group
addres
ses
data
value
Control command
The control command for the action is integrated
here, e.g. SHT for shutter modules. Further
modules in preparation.
Group addresses
A maximum of 8 group addresses can be
assigned to each 1-Wire module.
Group addresses are available in a range from
1-240.
Data value
A data value in the range 0-254 can be written to
the 1-Wire modules. Data values from 1 to 3 are
available for shutter modules.
For 8-fold output modules the data value of 0-254
can be sent.
Data return
Each OWD module gives its own individual
feedback.
GRPDEL
OWD
numb
er
1-30
Deletes a group address of an OWD number.
To carry out the deletion permanently, new group
addresses need to be saved permanently.
GRPDELALL
OWD
numb
er
1-30
or all
OWDs
All group addresses per OWD or alternatively all
group addresses can be deleted.
Delete OWD group addresses
by specifying the
OWD number.
Delete all group addresses
with the OWD
number 100.
GRPSET
OWD
numb
er
1-30
group
address
Assign a group address in the range of 1-240.
If this group address already exists, a response is
given. No group address can be assigned twice to
an OWD.
A maximum of 8 group addresses can be
assigned per OWD.
GRPSAVE
1
Permanent storage of the group addresses within
the 1-Wire Controller /
1-Wire Gateway / Station-200.
GRPDELAY
value
Sets the delay between group commands in the
range of 50ms to 1000ms.
Value setting is 400ms delay.
