All rights reserved. Reproduction as well as electronic duplication of this guide, complete or in part, requires the written consent of ESERA-
Automation or E-Service GmbH. Errors and technical modification subject to change.
©
ESERA-Automation, E-Service GmbH 2019
www.esera.de
Programming Manual Controller-Gateway-Station V1.0 R1.1
Page 66 of 77
Loads the entire factory settings
•
Settings are reset
•
Deletes the One Wire List (OWD List)
DATAPRINT
0-1
Sets the operating mode for the data output of
the sensor data
0 = in one line with one CR
1 = Continuous output with separator "|".
Default=1
DATATIME
0 or 10-
240
Set the cycle time for sending the 1-Wire data,
0=only query, cycle time=10-240 seconds
KAL
1
KAL signal
KALSEND
0-1
KAL message send on/off, default: on=1
KALSENDTIME
60-240
Set time for KAL send message,
Range 60-240 seconds, default=60
KALREC
0-1
KAL message receiver on/off, default: on=1
KALRECTIME
60-240
Sets time for KAL receiver message,
Range 60-240 seconds, default=65
KALALARM
OWD
No.
or
0 for
SYS
outp
ut
valu
e
Assigns the alarm output if the KAL signal of
the higher-level system is missing.
The internal relays can also be used for
Controller 2 or Gateway 20.
In this case, enter 0 for the OWD number.
LIZ
1-10
key
unlock options
License:
1: Codesys Lib
LIZDEL
1-10
1
Deletes license key
OUTH
0-31
Sets all digital outputs
0 = all channels off
OUT*
output
0 or 1
Sets a digital output
0 = off 1= active
OUTA*
value
Analog value 0-10V = 0-1000
DIO*
0-3
Function of the digital inputs
1 and 2 only input, 3 and 4 switches the digital
outputs
BTID
1000-9999
Password / key for Bluetooth data connection.
Key 1304 is set at the stage of delivery.
Not for modules without BT interface!
*
This function is only available for the 1-Wire Controller 2, 1-Wire Gateway 20 and Station 200.
