C
Remove the roll paper from the roll stand, slide
the roll paper right until it contacts the adapter
guide, and then slide the roll slowly inside.
D
Press the
M
button on the control panel.
Confirm that
Roll Paper
is highlighted in the
display and press the
Z
button.
E
Make sure that the roll paper is free of slack
and the end is not folded, and then insert it into
the paper slot.
When Auto Loading - ON
When roll paper is being inserted, a beep tone
sounds. If you hear the sound, proceed to Step 6.
When Auto Loading - OFF
Pull the edge of the paper straight outside the
printer as shown.
If the edge of the paper is not a horizontal or
not cut cleanly, you can use the built-in cutter
to make a cut in Step 6.
Note:
The cloth in the paper slot section may have been
reversed by the paper which was previously
loaded. If the cloth reverses, load the paper while
pushing the reversed part down with the leading
edge of the paper.
F
While lightly pressing the roll paper, lower the
lock lever, and press the
Z
button.
When
Auto Loading
is set to
Off
, you can cut
the edge of the roll paper with the built-in
cutter by pressing the
Z
button, and then
pressing the
)
button within 5 seconds.
G
Close the roll paper cover.
H
Check the media type.
U
“Checking and Setting the Paper Type” on
SC-P20000 Series/SC-P10000 Series User's Guide
Basic Operations
34
