Setup menu
Printer Setup
*1: Only displayed when the optional hard disk unit or Adobe PostScript 3 Expansion Unit has been connected.
* Default setting
Roll Paper Setup
Item
Description
Auto Cut
On
*
Choose
On
to automatically cut roll paper using the built-in cutter as
each page is printed or
Off
to disable auto paper cutting. The
setting selected with the printer driver takes priority when the
printer driver is used.
Off
Refresh Margin
On
*
If
On
is selected during borderless printing, the printer will
automatically trim the leading edge to remove any ink stains that
may have been left by the previous copy; to disable this feature,
choose
Off
.
Off
Page Line
On
*
If
Auto Cut
is
Off
, you can choose to print (
On
) or not print (
Off
) cut
lines on roll paper. Cut lines are not printed if
Auto Cut
is
On
or
when cut sheets or poster board is used.
Note, however, that if the roll width selected with the computer is
narrower than the paper loaded in the printer, cut lines will be
printed regardless of the option selected for
Auto Cut
.
The setting selected with the printer driver takes priority when the
printer driver is used.
Off
Roll End Option
Continue
Select the action to perform for a roll after replacement: print the
remaining data (
Continue
) / do not print (
Stop Printing
again from the beginning (
Reprint
).
Stop Printing
*
Reprint
*1
Roll Paper Ten-
sion
1 to 5 (3
*
)
This setting is used if
Extra High
is set as one of the following
settings: Paper menu -
Custom Paper Setting
-
Roll Paper Tension
,
or
Paper Configuration
-
Roll Paper Back Tension
in the printer
driver. If the paper wrinkles while printing even if
Feed Lateral
Adjust
is set to
Off
in
Printer Setup
-
Roll Paper Setup
from the
Setup menu, and
Roll Paper Tension
is set to
High
, select
Extra
High
and then set the back tension. Higher values produce higher
tension.
Auto Loading
On
*
Normally, leave the setting at
On
.
If you experience problems with automatic loading when you use
commercially available paper because of slipperiness, extremely
large curls, lack of tension, or other problems, set to
Off
.
Remove all paper before configuring this setting. If paper is loaded,
the setting cannot be changed.
Off
Feed Lateral Ad-
just
Normal
*
This should usually be set to
Normal
.
To prevent paper from being fed askew while printing, set this to
On
. When wrinkles appear while printing on thin paper, set this to
Off
. If the same items are set in
Custom Paper Setting
from the
Paper
menu, priority is given to this setting.
On
Off
SC-P20000 Series/SC-P10000 Series User's Guide
Using the Control Panel Menu
130
