Epson IR-320, Technical Reference Manual

Page: 47 / 340

Rev. C Setup 2-9
IR-320 Technical Reference Manual
Confidential
7. When removing the HDD drive, remove the four screws for the HDD drive as shown in the
figure below, and remove it.
(2) Installing the HDD
1. Install the HDD in the HDD unit, and attach it with four screws.
2. When you use two HDDs, set the jumpers to make one a “master” and the other a “slave.”
To make an HDD a master drive, remove the jumper. To make an HDD a slave, set the
jumper.
Note:
When you use two drives, one must be a master and one must be a slave. The IR-320 will not boot
from the slave drive.
An HDD may be set to either a master or slave, whether it is installed in the upper drive bay or the
lower drive bay.
removing the HDD in the lower drive bay removing the HDD in the upper drive bay
installing the HDD in the lower drive bay installing the HDD in the upper drive bay