Epson IR-320, Technical Reference Manual

Page: 166 / 340

3-54 OS and Drivers Rev. C
Installation for MS-DOS Locally Procured Version
Installation Procedure
If you install MS-DOS Locally procured version, follow the steps below.
Installing the CD-ROM Driver
After installing the MS-DOS locally procured edition only, the CD-ROM drive of the IR-320 is
not recognized. Therefore, use other PC to read the CD-ROM, and install the CD-ROM driver to
the IR-320 after copying the CD-ROM driver to a floppy disk from the Driver CD-ROM for the
IR-320.
Note
When using the CD-ROM driver, MSCDEX.EXE of MS-DOS is needed.
Install the CD-ROM driver by the following procedure.
1. Start the other PC to read the CD-ROM, and insert the Driver CD-ROM for the IR-320 to the
CD-ROM drive. Insert a formatted floppy disk in the FDD.
Touch Panel Driver Installation
Install the Touch Panel Driver from the CD-ROM for the IR-320.
Operating System Installation
Insert the MS-DOS startup disk and turn on the IR-320 to perform the Setup.
As for the installation procedure, refer to the MS-DOS manual.
CD-ROM Driver Installation
As for installing MS-DOS only, the CD-ROM drive for the IR-320 is not
recognized. Therefore, by using other PC to read the CD-ROM, install the
CD-ROM driver in the IR-320 after copying the CD-ROM driver on the floppy
disk from the Driver CD-ROM for the IR-320.
Network Driver Installation
The Network Driver is provided in the form compressed in the Driver
CD-ROM for the IR-320, but MS-DOS cannot extract the compressed file.
Therefore, by using other PC to read the CD-ROM, install the Network driver
toin the IR-320 after extracting the Network driver in the Driver CD-ROM for
the IR-320.