Epson EPL-7000, User Manual

Page: 295 / 330

HP Emulation Mode
EPL-7000 LaserJet series IIP
Resident fonts
14 7
Max. number of
downloaded fonts depends on amount of
memory depends on amount of
memory
Max. number of fonts
per page
depends on amount of
memory depends on amount of
memory
Page buffer mode Built-in Not available
Printable area
The size of the printable area for the LaserJet series III’ and this
printer is the same. The maximum number of characters that can
be printed per line is also the same. However, the absolute print
position may not be exactly the same as a printout from an HP
LaserJet series IIP printer.
In order to match your printing to the output produced on a
LaserJet printer, you can use the T-OFFSET and L-OFFSET feature
of the SYSTEM CONFIG option to make fine adjustments to the
print start position. However, because the offset feature can move
the printing position to a point outside of the printable area, some
of the data may not be printed.
Character clipping
If a character is partially outside the printable area, the HP LaserJet
does not print any portion of the character. The EPL-7000 prints
that
portion of the character that falls within the printable area.
Paper handling
When using the printer in HP emulation mode, the paper size is
not determined by the paper cassette as it is with an HP LaserJet
printer. Use the P-SIZE option in SelecType Level 1 to set any of
the fourteen paper sizes supported by the printer. For certain
nonstandard sizes of paper, you may need to use the manual feed
option described in Chapter 4.
C-4 Appendix C