Epson EPL-7000, User Manual

Page: 84 / 330

SelecType Options
Since the amount of RAM you reserve with this option is not
available for any other purpose, it is best to leave the setting at 0
until you see a SET FULL PRINT message. Then, increase the
setting in small increments until the error does not occur.
If FULL PRINT is set to the maximum value, the SET FULL
PRINT error is not displayed. If an INSUFF. MEMORY or PAGE
BUFFER FULL message appears, installing optional memory is the
only solution. See Appendix A for information on extra memory
options.
-64
to +63
You can use the T-OFFSET (top offset) option to make fine
adjustments in the position of the printing on the page. The setting
is in dots; each dot is 1/300th of an inch
(0.0846
mm) so you can
use this option to raise or lower the printing on the page up to
approximately 1/5th of an inch. The factory setting is 0.
-64
to +63
Use the L-OFFSET (left offset) option to make fine adjustments in
the position of the printing on the page. The setting is in dots;
each dot is 1/300th of an inch (0.0846 mm). With this option, you
can move the printing on the page approximately 1/5th of an inch
to the left (settings from -1 to -64) or to the right (settings from
1
to
i-63).
The factory setting is 0.
SelecType
3-21