Enterasys X-Pedition XSR, Cli Reference Manual

Page: 522 / 684

Other ADSL Commands
13-96 Configuring ADSL
Example
The following example sets the OAM frequency to 20 seconds:
XSR(config-if<ATM0/1/0.1>)#oam-pvc manage 20
oam retry
This command configures parameters related to OAM cell handling for ATM VC management.
This command requires a properly configured ATM sub ‐ interface.
Syntax
oam retry up-count down-count retry-frequency
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no oam retry
Mode
ATM Sub ‐ Interface configuration:
XSR(config-if<ATM x / x / x . x >)#
Default
• Initial down ‐ count value: 5
• Initial up ‐ count value: 3
• Initial retry ‐ frequency value: 10
• Default settings apply only when OAM management has been enabled with the
oam-pvc
command.
Example
This example sets the up ‐ count to 5 , the down ‐ count to 8, and the retry ‐ frequency to 2 seconds:
XSR(config-if<ATM0/1/0.1>)#oam retry 5 8 2
pvc
This command sets the sub ‐ interface circuit type to PVC and specifies ATM VPI/VCI values. This
command requires a properly configured ATM sub ‐ interface.
up-count
Sum of consecutive end ‐ to ‐ end F5 OAM loopback cells responses that must
be received to change the VC connection state to up. Range: 0 to 255.
down-count
Sum of consecutive end ‐ to ‐ end F5 OAM loopback cells responses that are not
received to change the VC connection state to down. Range: 0 to 255.
retry-
frequency
Interval between sending end ‐ to ‐ end F5 OAM loopback cells when a change
in the up/down state of a VC is being verified. Range: 1 to 3600 seconds.