Enterasys X-Pedition XSR, Cli Reference Manual

Page: 200 / 684

RIP Commands
5-124 Configuring the Internet Protocol
Mode
Router configuration: XSR(config-router)#
Example
The following example sets the RIP administrative distance to 85 :
XSR(config)#router rip
XSR(config-router)#distance 85
distribute-list
This RIP command filters networks received in updates/suppresses networks from being
advertised in updates.
Syntax
distribute-list access-list-number { in | out } [ type num ber]
Syntax of the “no” Form
The no form of this command removes the filter:
no distribute-list access-list-number { in | out } [ type number ]
Mode
Router configuration: XSR(config-router)#
Default
No filter applied
Example
The following example suppresses network 192.5.34.0 from being advertised in updates on
FastEthernet interface 1:
XSR(config)#access-list 1 deny 192.5.34.0 0.0.0.255
XSR(config)#router rip
XSR(config-router)#distribute-list 1 out fastethernet 1
access-list number
IP access list number, ranging from 1 to 199. The list defines which
networks will be sent and suppressed in routing updates.
in
Applies the access list to incoming routing updates.
out
Applies the access list to outgoing routing updates.
type
Interface type: ATM, BRI, Dialer, Fast/GigabitEthernet, Loopback,
Multilink, Serial, or VPN.
number
Interface number on which the access list should be applied. If no
interface is set, the ACL will be applied to all updates.