Enterasys X-Pedition XSR, Cli Reference Manual

Page: 363 / 684

PPP Commands
XSR CLI Reference Guide 8-93
Syntax
ppp pap sent-username [ username ] password [ password ]
Syntax of the “no” Form
Use the no form of this command to delete the username and password:
no pap sent-username
Default
No username or password
Mode
Interface configuration: XSR(config-if< xx >)#
Example
This example configuration of a the PAP authentication username of jim and a clear text PAP
password of evans on serial interface 2/1 :
XSR(config)#interface serial 2/1
XSR(config-if<S2/1>)#encapsulation ppp
XSR(config-if<S1/1>)#no shutdown
XSR(config-if<S2/1>)#ppp pap sent-username jim pass evans
ppp peer default ip address
This command specifies the default IP address of a remote peer for use during PPP/IPCP
negotiation if the peer requests it. The address is used when the remote peer sends a 0.0.0.0 IP
address in the CONFIG REQUEST and asks the local system to assign an IP address. The address
will not be used if the peer already has been assigned an IP address with its own local
configuration.
This command can be used for Interface Serial, T1/E1 channel groups, BRI leased line with PPP
encapsulated; Ethernet sub ‐ interface and ATM sub ‐ interface with PPPoE or PPPoA encapsulated.
When used at the dialer interface, it applies to the Point ‐ to ‐ Point (P2P) dialer interface only. For
Dialer Multipoint ‐ to ‐ Point interfaces, the
dialer map ip
command supplies the remote address
associated with particular dialing numbers.
username
Username sent in the PAP authentication request packet.
password
The clear text password sent in the PAP authentication request packet. Limit: up
to 255 ASCII characters. Enclose password in double quotes if entering a string
with spaces
Note: The peer default IP address takes effect only when the peer is configured as IP address
negotiated .