Enterasys X-Pedition XSR, Cli Reference Manual

Page: 390 / 684

Multilink PPP Commands
8-120 Configuring the Point-to-Point Protocol
Syntax
multilink load-threshold number ( 1-255 )
Default
255
Mode
Dialer Interface configuration: XSR(config-if< xx >)#
Example
The following example sets the multilink PPP load threshold to 250 on the terminating Dialer
interface:
XSR(config)#interface dialer 4
XSR(config-<D4>)#multilink load-threshold 250
ppp multilink multi-class
This command enables Multi ‐ Class MLPPP (Multilink PPP) for the Multilink PPP header format
providing Quality of Service (QoS) for selected packets between peers. It supports five streams of
sequence numbers, the long sequence format by default, and the short sequence number by
negotiation. Any class lower than the default requested by the peer will be accepted, and higher
than the default will eventually trigger a reject message if the value is accepted by the peer.
Syntax
ppp multilink multi-class
Syntax of the “no” Form
The no form of this command disables multi ‐ class MLPPP:
no ppp multilink multi-class
Defaults
• Long sequence number
• Accept negotiation for short sequence number
• Accept any suspendable (class) level less than or equal to 5
• Disabled
Mode
Dialer or Multilink Interface configuration:
XSR(config-if< xx >)#
1-255
Load on the port: 255 indicates it has reached 100% of bandwidth.