Enterasys X-Pedition XSR, Cli Reference Manual

Page: 514 / 684

Other ADSL Commands
13-88 Configuring ADSL
interface atm
This command creates an ATM interface object and its associated device driver which downloads
the specified firmware file to the on ‐ board DSP. Depending on the size of the DSP firmware and
the characteristics of the download procedure, this procedure may take a noticeable amount of
time. After a successful load, the interface and device driver is in the administrative down state
( shutdown ).
Syntax
interface atm { slot / card / port }
Syntax of the “no” Form
The no form of this command removes the interface object and all associated sub ‐ interface objects.
The interface must be shut down first.
no interface atm { slot / card / port }
Mode
Global configuration: XSR(config)#
Next Mode
ATM Interface configuration: XSR(config-if<ATM xx >)#
Example
The following example creates an ATM interface on slot 0 , card 1 , port 1 :
XSR(config)#interface atm 0/1/1
XSR(config-if<ATM0/1/1>)#
interface atm sub-interface
This command creates an ATM sub ‐ interface object and associates it with its ATM interface peer.
Setup of internal data paths, which will route an IP interface to the ATM sub ‐ interface, will
continue as configuration proceeds and a no shutdown command has been issued against this
sub ‐ interface instance. On successful construction, the sub ‐ interface is in the administrative down
state ( shutdown ).
This command requires that the ADSL NIM be installed, the DSP firmware file be present in the
Flash: directory, and the ATM port be properly configured.
The following commands are sub ‐ commands of atm sub-interface :
Caution: This command requires that the ADSL NIM be installed and the DSP firmware file be
present in the Flash: directory.
slot
The XSR slot number, ranging from 0 to 2.
card
The XSR NIM number, ranging from 1 to 2.
port
The XSR slot number: 0. The sub ‐ interface number ranges from 1 to 30.