Enterasys X-Pedition XSR, Cli Reference Manual

Page: 439 / 684

Dialer Interface Commands
XSR CLI Reference Guide 10-85
Mode
Interface configuration: XSR(config-if< xx >)#
Example
The following example shows dialer interface 0 assigned to dialer pool 6.
XSR(config)#interface dialer 0
XSR(config-if<D1>)#dialer pool 6
XSR(config-if<D1>)#no shutdown
dialer pool-member
This command configures physical interfaces for dial devices only.
Syntax
dialer pool-member number [ priority priority ]
Syntax of the “no” Form
no dialer pool-member number
Defaults
• Disabled. When enabled, no default dialing pool number is assigned
• Priority: 0
• Minimum: 0
• Maximum: 255
Mode
Interface configuration:
XSR(config-if< xx >)#
Example
The following example shows a serial interface belonging to two dialer pools with priorities
configured for each pool:
XSR(config-if)#interface serial 1/0
XSR(config-if<S1/0>)#dialer pool-member 1 priority 10
XSR(config-if<S1/0>)#dialer pool-member 2 priority 20
XSR(config-if<S1/0>)#no shutdown
Note: This command is intended for dialer interfaces only.
number
Dialpool number ranging from 1 to 255.
priority
Priority of the interface within the dialing pool - ranging from 0 (lowest) to 255
(highest). Ports with the highest priority are selected first for dialing out.