Enterasys X-Pedition XSR, Cli Reference Manual

Page: 452 / 684

DOD/BOD Commands
10-98 Configuring the Dialer Interface
Example
The following example maps ACL 1350 to dialer list 57:
XSR(config)#access-list 57 permit ip 0.0.0.0 255.255.255.255 255.255.255.255 0.0.0.0
XSR(config)#dialer-list 57 protocol ip list 1350
dialer called
This command maps incoming calls to one of the dialer interfaces. A maximum number of 32
called numbers per dialer interface can be configured.
Syntax
dialer called DNIS:subaddress
Syntax of the “no” Form
The no form of this command removes the configured number:
no dialer called DNIS:subaddress
Mode
Dialer Interface configuration:
XSR(config-if<D x >)#
Example
The following example configures a dialer profile for a receiver with DNIS 12345 and ISDN
subaddress 6789 :
XSR(config)#interface dialer 1
XSR(config-if<D1>)#dialer called 12345:6789
dialer caller
This command configures caller ID screening with an option providing ISDN callback. The XSR
will accept calls from a specified phone number. A maximum of 32 caller numbers can be set per
dialer port.
The command matches numbers starting with the least significant digits of the calling number,
starting from the last digit. Typically the ISDN switch does not provide the complete calling
number, only the local number (four to seven of the least significant digits).
The dialed number must be configured in the Dialer interface.
Syntax
dialer caller number [ callback ]
DNIS:subaddress
Dialed Number Identification Service, or the called party number, a colon, and
the ISDN subaddress.
number
Phone number to screen. Limit: 32 characters.
callback
Returns the call to the dialer. This option applies to DoD applications and supports
PPP and MLPPP. If used in a backup capacity, set the number of retries to 1.