Enterasys X-Pedition XSR, Cli Reference Manual

Page: 386 / 684

Multilink PPP Commands
8-116 Configuring the Point-to-Point Protocol
entered, no maximum fragment size will be set and the fragment size will only be decided with
the load balance.
Syntax
ppp multilink fragment-delay value
Syntax of the “no” Form
The no form of this command deletes the fragment ‐ delay setting:
no ppp multilink fragment-delay
Mode
Interface configuration: XSR(config-if< xx >)#
Default
10 milliseconds
Example
The following example sets the fragment ‐ delay to 30 milliseconds on the Dialer 2 interface:
XSR(config-if<D2>)#ppp multilink fragment-delay 30
Table 8-1 Maximum Fragment Size (bytes)/Fragment Delay (ms)
Link Speed Fragment Delay (ms)
5 ms 10 ms 20 ms 50 ms 100 ms 500 ms 1000 ms
56 kbps 35 70 140 280 560 1120 1500
64 kbps 40 80 160 320 640 1280 1500
128 kbps 80 160 320 640 1280 1500 1500
256 kbps 160 320 640 1280 1500 1500 1500
512 kbps 320 640 1280 1500 1500 1500 1500
768 kbps 640 1280 1500 1500 1500 1500 1500
1536 kbps 1280 1500 1500 1500 1500 1500 1500
2024 kbps 1500 1500 1500 1500 1500 1500 1500
value
Delay interval ranging from 10 to 1000 in milliseconds.