Enterasys X-Pedition XSR, Cli Reference Manual

Page: 437 / 684

XSR CLI Reference Guide 10-83
10
Configuring the Dialer Interface
This chapter describes commands for the dialer, dialer backup, and Dial ‐ on ‐ Demand/Bandwidth ‐
on ‐ Demand services.
Observing Syntax and Conventions
The CLI command syntax and conventions use the notation described in the following table.
Dialer Interface Commands
The following set of commands defines dial services on the XSR:
• Dialer Interface Clear and Show commands on page 10 ‐ 90 .
• Dialer Backup commands on page 10 ‐ 93 .
• DOD/BOD commands on page 10 ‐ 96 .
• Dialer Watch commands on page 10 ‐ 103 .
dialer dtr
This command specifies that a non ‐ V.25bis modem using Electronic Industries Association (EIA)
signaling will be used on the serial line interface. This signal is known as the DTR signal. The
dialer string
command has no effect on DTR dialers. Be aware of the following mandatory
conditions:
Convention Description
xyz
Key word or mandatory parameters ( bold )
[ x ]
[ ] Square brackets indicate an optional parameter ( italic )
[ x | y | z ]
[ | ] Square brackets with vertical bar indicate a choice of values
{ x | y | z }
{ | } Braces with vertical bar indicate a choice of a required value
[ x { y | z } ]
[{ | } ] Combination of square brackets with braces and vertical bars indicates a
required choice of an optional parameter
(config-if< xx> )
xx signifies interface type and number, e.g.:
F1, S2/1.0, D1, M57, L1,
ATM0/1/1
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis