EnGenius EDS1130, User Manual

Page: 15 / 185

15
Chapter2
|
Installation
Connecting via Wi-Fi Setup
It is recommended that to make initial setup with RJ-45 Ethernet cable and then switch to wireless after you have completed
all the settings. However, you can also start wirelessly with WPS mechanism.
Note: Ensure the gateway/router supports WPS feature and confirm that the feature is enabled.
Make sure two devices are close enough and the gateway/router is not occupied by heavy traffic or P2P loading.
I. Press the WPS button (shown below) on your gateway or router until WPS LED blinks.
II. Press and hold the WPS button on the back of your camera for 1-5 seconds and the Wi-Fi LED will start blinking
frequently. When the connectivity is complete, the Wi-Fi LED will become solid green. The process may take up to 1 minute.
Please note that there may be differences in WPS between brands; therefore, if the gateway or router does not respond to camera
connection request properly, please use RJ-45 cable for initial setup and manually configure wireless setting afterwards. Please refer
to Chapter 3 for manual wireless setup.
WPS
1~5 SECs
60 SECs
I. II.