Endress+Hauser Prosonic Flow 90, Operating Instructions Manual

Page: 3 / 114

Proline Prosonic Flow 90 Brief operating instructions
Hauser 3
!
Note!
Always start trouble-shooting with the checklist on Page 79, if faults occur after startup.
▼
“SENSOR INSTALLATION” Quick Setup Page 64, 67
Measuring devices with a local display:
Use this “Quick Setup” (
→
Page 64) to determine the data required for sensor installation
such as sensor distance (1), wire length, pipe materials, sound velocity in liquids, etc.
– The system provides you with the sensor distance for the W/P/U “clamp-on” versions as
distance data. For the W and P sensors, you also receive the data in the form of a letter for
sensor 1 and in the form of a number for sensor 2. You can thus easily position the sen-
sors with the aid of the mounting rail.
– With the butt-weld version, you receive the sensor distance as distance data.
Measuring devices without a local display:
No “Sensor Installation” Quick Setup is available for devices without a local display.
The sensor installation procedure for such devices is explained on
→
Page 67.
Connection of the sensor/transmitter connecting cable
→
Page 35
A0001054
▼
Commissioning via “QUICK SETUP”
Commissioning via “ToF Tool - Fieldtool Package”
Page 65, 67
Measuring devices with a local display:
You can commission your measuring device quickly and easily using the special “Quick
Setup” menu
→
Page 65. This means that important basic functions can be configured
directly via the local display, e.g. display language, measured variables, engineering units,
etc.
Where necessary, the following adjustments and configurations must be carried out
separately:
– Zero point adjustment
– Bus address
– Tag name
– Configuration of the totalizers
Measuring devices without a local display:
– No “Commissioning” Quick Setup is available for devices without a local display.
The commissioning procedure for such devices is explained on
→
Page 67
A0001055
▼
Customer-specific configuration Page 45 ff.
Complex measurement tasks require the configuration of additional functions which you
can individually select, set and adapt to your process conditions using the function matrix.
There are two options:
– Setting parameters via the configuration program “ToF Tool - Fieldtool Package”
– Setting parameters via the local display (optional)
All functions are described in detail, as is the function matrix itself, in the “Description of
Device Functions” manual, which is a separate part of these Operating Instructions.
A0001056
1
1
1
1
…
…
…
…
…
…
…
…
0001
2001
0401
2021
2201
0002
2002
0402
2022
2202
0003
2003
0403
2023
2203
0009
2009
0409
2029
2209
0429
2049
2069
0421
2041
0422
2042
0423
2043
2063 2061 2062
0000
2000
0400
2020
2200
0420
2040
2060
000
200
040
202
220
042
204
206
AAA
BAA
ACA
CAA
CBA
A
B
C
D, E, …