Endress+Hauser Proline Cubemass 300, Description Of Device Parameters

Page: 165 / 294

Proline Cubemass 300 Modbus RS485 Description of device parameters
Hauser 165
Additional information Selection
• Off
The terminating resistor is disabled.
• On
The terminating resistor is enabled.
For detailed information about enabling the terminating resistor, see the Operating
Instructions for the device, "Enabling the terminating resistor" section→  7
Fieldb.writ.acc.
Navigation  Expert → Communication → Modbus config. → Fieldb.writ.acc. (7156)
Description Use this function to restrict access to the measuring device via fieldbus (Modbus protocol).
Selection • Read + write
• Read only
Factory setting Read + write
Additional information Description
If read and/or write protection is enabled, the parameter can only be controlled and reset
via local operation. Access is no longer possible via operating tools.
This does not affect cyclic measured value transmission to the higher-order system,
which is always guaranteed.
Selection
• Read + write
The parameters are read and write parameters.
• Read only
• The parameters are read only parameters.
3.6.2 "Modbus info" submenu
Navigation  Expert → Communication → Modbus info
‣
Modbus info
Device ID (7153) →  166
Device revision (7154) →  166