Endress+Hauser Micropilot FMR50, Operating Instructions Manual

Page: 50 / 184

Operation options Micropilot FMR51, FMR52 HART
50 Hauser
8.2 Structure and function of the operating menu
8.2.1 Structure of the operating menu
Menu Submenu /
parameter Meaning
Language
1)
Defines the operating language of the on-
site display.
Setup Parameter 1
...
Parameter N When all these parameters have been
assigned appropriate values, the measured
should be completely configured in a
standard application.
Advanced setup Contains further submenus and
parameters:
• to adapt the device to special measuring
conditions.
• to process the measured value (scaling,
linearization).
• to configure the signal output.
Diagnostics Diagnostic list Contains up to 5 currently active error
messages.
Event logbook
2)
Contains the last 20 messages (which are
no longer active).
Device information Contains information needed to identify
the device.
Measured values Contains all current measured values.
Data logging Contains the history of the individual
measuring values.
Simulation Used to simulate measured values or
output values.
Device check Contains all parameters needed to check
the measurement capability of the device.
Heartbeat
3)
Contains all wizards for the Heartbeat
Verification and Heartbeat Monitoring
application packages.
Expert
4)
Contains all parameters of the device
(including those which are already
contained in one of the above submenus).
This menu is organized according to the
function blocks of the device.
The parameter of the
Expert menu are
described in:
GP01014F (HART)
System Contains all general device parameters
which do not affect the measurement or
the communication interface.
Sensor Contains all parameters needed to
configure the measurement.
Output • Contains all parameters needed to
configure the current output.
• Contains all parameters neeed to
configure the switch output (PFS).
Communication Contains all parameters needed to
configure the digital communication
interface.
Diagnostics Contains all parameters needed to detect
and analyze operational errors.
1) In case of operation via operating tools (e.g. FieldCare), the "Language" parameter is located at "Setup →
Advanced setup → Display"
2) only available with local operation
3) only available for operation via DeviceCare or FieldCare
4) On entering the "Expert" menu, an access code is always requested. If a customer specific access code has
not been defined, "0000" has to be entered.