Micropilot FMR51, FMR52 HART
Operating menu
Hauser
153
Selection
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting
x.xxxx
Additional information
• Is only valid for numbers in the operating menu (e.g.
Empty calibration
,
Full
calibration
), but not for the measured value display. The number of decimal places for
the measured value display is defined in the
Decimal places 1 to 4
parameters.
• The setting does not affect the accuracy of the measurement or the calculations.
Backlight
Navigation
Setup → Advanced setup → Display → Backlight
Prerequisite
The device has the SD03 local display (with optical keys).
Description
Switch the local display backlight on and off.
Selection
• Disable
• Enable
Factory setting
Disable
Additional information
Meaning of the options
•
Disable
Switches the backlight off.
•
Enable
Switches the backlight on.
Regardless of the setting in this parameter the backlight may be automatically
switched off by the device if the supply voltage is too low.
Contrast display
Navigation
Setup → Advanced setup → Display → Contrast display
Description
Adjust local display contrast setting to ambient conditions (e.g. lighting or reading angle).
User entry
20 to 80 %
Factory setting
Dependent on the display.
Additional information
Setting the contrast via push-buttons:
• Darker: press the and
E
buttons simultaneously.
• Brighter: press the and
E
buttons simultaneously.
Summary of Contents for Micropilot FMR50
Page 183: ......
Page 184: ...www addresses endress com 71344017 71344017 ...