Endress+Hauser Micropilot FMR50, Operating Instructions Manual

Page: 139 / 184

Micropilot FMR51, FMR52 HART Operating menu
Hauser 139
"Current output 1 to 2" submenu
The Current output 2 submenu (→  139) is only available for devices with two
current outputs.
Navigation  Setup → Advanced setup → Curr.output 1 to 2
Assign current output 1 to 2 
Navigation  Setup → Advanced setup → Curr.output 1 to 2 → Assign curr.
Description Select process variable for current output.
Selection • Level linearized
• Distance
• Electronic temperature
• Relative echo amplitude
• Analog output adv. diagnostics 1
• Analog output adv. diagnostics 2
• Area of incoupling
Factory setting • Current output 1: Level linearized
• Current output 2
8)
: Relative echo amplitude
Additional information Definition of the current range for the process variables
Process variable 4 mA value 20 mA value
Level linearized 0 %
1)
or the associated
linearized value
100 %
2)
or the associated linearized value
Distance 0 (i.e. level is at the reference
point) Empty calibration (→  109) (i.e. level is at
0 %)
Electronic temperature –50 °C (–58 °F) 100 °C (212 °F)
Relative echo amplitude 0 dB 150 dB
Analog output adv.
diagnostics 1/2 depending on the parametrization of the Advanced Diagnostics
Area of incoupling 0 100
1) the 0% level is defined by Empty calibration parameter (→  109)
2) The 100% level is defined by Full calibration parameter (→  109)
It may be necessary to adjust the 4mA and 20mA values to the application (especially
in the case of the Analog output adv. diagnostics 1/2 and Area of incoupling
options).
This can be done by the following parameters:
• Expert → Output → Curr.output 1 to 2 → Turn down
• Expert → Output → Curr.output 1 to 2 → 4 mA value
• Expert → Output → Curr.output 1 to 2 → 20 mA value
8) only for devices with two current outputs