Endress+Hauser Deltabar FMD71, Description Of Device Parameters

Page: 46 / 68

Description of device parameters Deltabar FMD71, FMD72
46
Options • °C
• °F
• K
Note The setting affects the unit for the "Sensor Temp." parameter.
Factory setting °F
Density unit (127)
Navigation Expert → Measurement → Level → Density Unit (127)
Write permission Service engineers/Expert
Description Displays the density unit. The measured pressure is converted to a height using the "Height
Unit", "Adjust Density" and "Process Density" parameters.
Options • g/cm 3
• kg/m 3
• kg/dm 3
• lb/in 3
• lb/ft 3
Factory setting g/cm 3
Electronics temp (128)
Navigation Expert → Measurement → Basic setup → Electronics Temp. (128)
Write permission No write permissions. Parameter is read only.
Description Displays the serial number of the sensor module HP (11 alphanumeric characters).
Lo trim measured (129)
Navigation Expert → Measurement → Sensor Trim HP → Lo Trim Measured (129)
Write permission No write permissions. Parameter is read only.
Description Displays the reference pressure present to be accepted for the lower calibration point.
Hi trim measured (130)