ENCAD NovaCut 24, User Manual, Page: 58 / 228

NovaCut User's Guide
3-8 Common Functions
Selecting the origin position (HP-GL mode only)
When the command mode is set to HP-GL, you can set the position of the origin
point to the lower left corner or center of the effective plotting area.
When the command mode is set to GP-GL mode, this setting is not available.
The registered origin position retained in memory even while the printer is
turned off. If the origin position is set to CENTER, the “X=” and “Y=” coordi-
nate values shown at the display panel represent the relative distance from the
lower left corner of the effective printing area.
➪ ➪
➪ ➪
➪
To select the origin position
1 Press PAUSE.
2 Press NEXT DISPLAY.
<PRINT CUTTING>
<SEL. MODE SETUP>
3 Press F4 (SETUP).
<CENTRO RS422>
Press F1 (CENTRO) to select the origin position for the Centronics-com-
patible parallel interface, or press F3 (RS422) to select it for the RS-422
serial interface.
4 Press ENTER.
ORIGIN POINT
LOWER LEFT CENTER
Press F2 to choose LOWER LEFT or F4 to choose CENTER.
5 Press Enter to save the origin position indicated by the blinking square.
6 Press PAUSE to return to READY status.