. . . . .
P R I N T E D C I R C U I T B O A R D S P E C I F I C A T I O N
Adjusting the Pin Chain Conveyor using the Motorized Width Adjust Option
2-9317-372-00-0
Bravo™ 8105 Programming and Operations Guide
5-63
Photograph
Figure 5–3
Adjusting the Pin Chain Conveyor using the Motorized Width Adjust Option
Introduction
The optional Motorized Width Adjust uses the computer interface to control the
width of the conveyor rails via software. Width adjust can be performed in either
Process Screen or in the Width Adjust Setup Screen. Refer to the following
section to perform width adjust using the software option.
Width Adjust in
Process Graphic
Screen
The Setpoint displays in the bottom parameter of the Width Adjust display on the
Process Graphic Screen. Refer to Figure 5–4. The Actual Width displays above
the Setpoint display.
To change the width setting, highlight the width parameter in the Setpoint field
and enter a new number.
Press Enter.
Click on the Start button below the setpoint.
The indicator is Red when the width adjust motor is On. It is Gray when the width
adjust motor is Off.
The rails stop automatically when they reach the width adjust setpoint. If it is
desired to stop the rails before they reach the setpoint, click on the Stop button.
