ELAD FDM-DUOr
User Manual - Rev. 1.1 - 04/2016
© 2016 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated in any form or
by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
76
Run Flash Magic and set the following parameters.
In the “Step 1 – Communication” section:
Select LPC1766,
COM Port: the CAT USB COM port,
Baud Rate: 230400,
Interface: None (ISP).
In the “Step 2 – Erase” section:
Check “Erase all Flash+Code Rd Prot”.
In the “Step 3 – Hex File” section:
Click on Browse and select the update “.hex” file.
In the “Step 4 – Options” section:
Check “Verify after programming”0
Check the communication with the FDM-DUOr clicking on “ISP” and then on “Read Device Signature”. If
the communication with the FDM-DUOr is working, a new window with some device information is
opened.
If the communication is working it is possible to proceed with the firmware update. Click on “close” on
the “Device Signature” window. In the Flash Magic main window, click on “Start” to begin the
programming. Wait until the end of the process, then turn off and on the FDM-DUOr.
