ELAD FDM-DUOr
User Manual - Rev. 1.1 - 04/2016
© 2016 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated in any form or
by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
17
The main controls are as follows:
The button is used to change to mode: at each short press the mode is changed to the next
possible mode.
Modes
The tuning is done using the main tuning knob.
It is possible to change the tuning step to an alternate value with a short pressure on the
button.
Another short pressure on the button resets the usual tuning step.
It is possible to change the tuning step to various values with a short pressure on the tuning knob.
This leads the tuning knob to select different tuning steps.
Once the desired step has been selected, another short pressure on the tuning knob will bring it back
to control the tuning, using the new selected step.
Tuning
The volume is set by the E1 knob.
The E2 knob controls the bandwidth.
Volume and bandwidth
FDM-DUOr does not have the “band” concept, thus there is no “band switch”.
There are, though, some special memories holding the value of the low frequency limit of each band
as factory settings.
The “Quick Mem” mode can be used to quickly reach the wanted band; it is activated by long
pressing the button.
Press and hold the button until the display shows the wanted band.
Bands
