ELAD FDM-DUOr
User Manual - Rev. 1.1 - 04/2016
© 2016 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated in any form or
by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
26
5.5
Settings Menu List
The following table describes the FDM-DUOr settings menu list. To enter the settings menu mode, press
the key. Use E2 to select the menu, then apply a short pressure on E2 to display the current menu
setting, if you want to change the setting use the E2 knob and confirm the setting with a short pressure
on E2. In some menu you can also use the main knob to change the setting more quickly. To turn back or
exit the menu just press .
Menu Title
Description
Available Settings
Default
RECEPTION MENU
1
RX ATT
Receiver input attenuation
0dB, 10dB, 20dB and 30dB
0dB
3
SNAP
Round to step
OFF or ON
ON
4
AGC TH
AGC Threshold
From 0 to 10
4
6
AUX VOL
Auxiliary output volume
From 0 to 100
50
7
QUICKSTEP
Step selected for the “QuickStep” mode
1Hz, 5Hz, 10Hz, 25Hz, 50Hz,
100Hz, 250Hz, 500Hz, 1kHz,
2kHz, 3kHz, 4.5kHz, 5kHz,
7.5kHz, 9kHz, 10kHz,
12.5kHz, 25kHz, 50kHz,
100kHz, 125kHz, 250kHz,
500kHz, 1MHz
1kHz
12
SET CW MODE
Enable / disable CW reverse mode
YES or NO
NO
GENERAL SETTINGS MENU
60
FR OFFSET
Enable / Disable the frequency offset for
the visualization
OFF or ON
OFF
61
OFS VALUE
Frequency offset value for the
visualization
+/- 99.999999999 GHz.
See
Frequency
visualization offset menu
0Hz
70
CAT BAUD
CAT serial port baud rate
9600, 38400,
57600, 115200
38400
71
HOLD TIME
Hold time to detect a long pressure
From 500 to 2500ms
1000ms
72
REPT TIME
Repetition time when a key is pressed
From 100 to 1500ms
600ms
73
BACKLIGHT
Enables the backlight to change when
the DUO changes modality between
Stand-Alone and Remote
YES or NO
YES
SERVICE MENU
80
SERVICE
Enable Service mode
ON or OFF
OFF
81
DEFAULT
Restore default parameters
YES or NO
NO
82
UI UPDATE
If Service mode is active, enable the
firmware update mode
YES or NO
NO
83
VIEW SN
Display the FDM-DUOr serial number
84
VIEW FW
Display the FDM-DUOr firmware
versions
Firmware
UI
85
CLK ADJ
Sets the internal clock correction value.
It is used to have a fine frequency
setting. In case of “Ref In” utilization,
this parameter is not relevant.
±50000 dots (not Hz)
-
