EDNord Magicolor 3300, User Manual

Page: 81 / 198

Cleaning the Printer
73
WARNING!
If you get toner in your eyes, wash it out immediately with cool water
and consult a doctor. Material Safety Data Sheets (MSDS) information
can be found at printer.konicaminolta.net/support (click on the Answer
Base).
Lift the printer from the bottom only, using the carrying grips. Make sure
that two people are available to lift the printer when moving it.
Do not place anything on the top of the printer.
Do not open any cover of the printer during printing.
Close the printer covers gently, and never expose the printer to vibrations.
Do not leave the printer’s covers open for any length of time, especially in
well-lit places; light may damage the imaging unit.
Attention
The OPCs in the imaging unit are extremely sensitive to bright light,
direct sunlight, and touch. Always leave the imaging unit in its
protective box until you’re ready to install it. Any exposure to light
should be limited to less than two minutes, or permanent damage
could result. Handle the unit carefully so you don’t touch the black
surface of the transfer roller.
Do not cover the printer immediately after using it. Turn it off and wait until
it cools down. When the front cover is opened, the fuser temperature
drops gradually (one hour wait time).
Cleaning the Printer
What are the printer’s internal cleaning cycles?
The image unit performs an automatic cleaning rotation after every page of
one-page simplex jobs and pages longer than 14"/355.6 mm, and between
pages of multipage jobs, depending on the amount of processing required
between pages. Cleaning cycles also occur at intervals (as shown below)
depending on the number of simplex pages printed.The printer
pauses for
approximately 30 seconds to do an automatic internal cleaning cycle during
long print jobs.
Image Unit Print Count Printer Pauses Every
x
Simplex Pages
0–5,119 48
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500