48
Introduction to Use of the PR-1000HD —
Turning the Power On and Off
* Once the connections have been completed (p. 17), turn on power to your various devices in the order specified.
By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other
devices.
* If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from
the power outlet.
■
Turning On the Power
1.
Refer to “Setting Up and Connecting Equipment” to confirm the connections.
2.
Turn on the power to all of the peripheral devices connected to the PR-1000HD.
3.
Lower the volume on all audio equipment (amps, mixers, etc.) to their minimum
level.
4.
Set the PR-1000HD’s rear panel power switch to the [-] position.
fig.front.power.eps
5.
Press the PR-1000HD’s front panel [POWER] switch.
fig.front.power.
fig.front.power.eps
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required
before the unit will operate normally.
6.
Selector is displayed. Select [Presenter].
fig.selector.eps
Turning the Power On and Off
Power switch
Do not hold down the
[POWER] button for four
seconds or longer.
POWER button
You can’t start up Presenter if
no removable hard disk drive is
connected to the PR-1000HD.
942
941
945
PR-1000HD_e.book 48 ページ ２００８年１月２１日 月曜日 午後８時３５分
Summary of Contents for PR-1000HD
