Edelbrock Pro-Tuner, User Manual

Page: 23 / 235

Installation and Setup 23
Figure 2
FUEL PUMP AND FILTER
The Victor/Super Victor Pro-Tuner system uses a single Edelbrock high-pressure electric
fuel pump which is capable of pumping 50 or more psi (depending upon the pump). The
pump relay will prime the system on key-up and shut down the pump if it does not
receive an engine-run signal from the ECU, as in the case of a stall. This safety
precaution is necessary when using a high-pressure fuel system. It is very important that
the fuel flow capacity of the EFI pump exceed your peak demand by 20-25% to avoid
engine damage due to loss of pressure. Electrical connectors should face the front of
vehicle when mounting. Consult your Edelbrock representative for assistance in pump
selection. A high pressure/high volume EFI fuel filter should be mounted between the
engine compartment and the fuel pump. A high quality inlet filter should also be
installed to protect the fuel pump from contamination. See Fig. 2. Consult your
Edelbrock representative for assistance in filter selection. Use the mounting instructions
for the pump and filters that you are using.
RECOMMENDED FUEL PUMP AND REGULATOR KITS