ECKELMANN Case Controller UA 4 E Series, Operating Instruction

Page: 204 / 466

Firmware V3.13 21.04.2021 204/466
•
•
•
•
•
Menu 2-5 Frame Heater
FRAME HTR POS: XXXXX
1 Mode frm htr Move to menu 2-5-1
2 Setpoint frm htr Move to menu 2-5-2
3 Mode altern. Move to menu 2-5-3; not shown when setpoint toggle is deactivated (Menu 3-3)
4 Setpoint altern. Move to menu 2-5-4;not shown when setpoint toggle is deactivated (Menu 3-3)
Menu 2-5-1 Frame Mode
Selection is made according to entry. Checkmark shows current setting.
MODE POS: XXXXX Entry Default
Fixed run time √ √
Enthalpy-ctrl rtm
Menu 2-5-2 Frame Setpoints
SETPOINTS POS: XXXXX Entry Default
Mod: xxxxxxxxxxxx Displays set frame mode (Menu 2-5-1) fixed run time
Run Time XXX % Fixed on time, shown only when mode set to
Fixed OT (Menu 2-5-1) --, 0..100 100 %
emerg.run time XXX % On time in loss of humidity or room air
temperature (via CAN bus); shown only when
mode set to Enthalpy Control (Menu 2-5-1) --, 0..100 100 %
enthalp. offs. XXX % Offset for on time when enthalpy control is
activated (via CAN bus); shown only when mode
set to Enthalpy Control (Menu 2-5-1) -50..50 0 %
Invert Output xxx Inversion of the function of the frame heater
output (terminals 91/92) ↑, ↓, (ON/OFF) ON
Menu 2-5-3 Toggle Mode
MODE ALT. POS: XXXXX Entry Default
Fixed run time √ √
Enthalpy-ctrl rtm
Menu 2-5-4 Setpoint Toggle
TOG. SETP. POS: XXXXX Entry Default
Mod: xxxxxxxxxxxx Displays set frame mode (Menu 2-5-3) fixed run time
Run Time XXX % Fixed on time, shown only when mode set to
Fixed OT (Menu 2-5-3) --, 0..100 100 %