26
EN
12. Attach the landing gear door to the strut using four 2mm x 8mm
self-tapping screws and a #0 Phillips screwdriver.
E-tips
Work slowly when using a sanding drum on the screws. The screws will
heat up while sanding, which could melt the landing gear door.
13. Use side cutters and a rotary tool with a sanding drum to smooth
the ends of the screws against the inside of the blocks. If this is not done,
the screws could catch on the edges of the retract opening and cause the
gear to not retract correctly.
14. Slide the landing gear door so the top block is resting against the
coil of the landing gear strut. Apply a thin bead of canopy glue along the
front and back of the strut against the landing gear door. Rotate the door a
few times to work the glue behind the strut.
15. Retract the landing gear using the radio system. This will set the
correct angle for the landing gear door against the wing. Allow the glue to
cure overnight before moving the gear back to the down position.
16.Repeat steps 1 through 15 to install the second landing gear door.
nose gear InstallatIon - FIxed gear
Required Parts
Fuselage assembly
Fixed nose gear assembly
Transmitter
Receiver
Receiver battery
Silicone tubing
Metal clevis (2)
2mm nut (2)
Threaded rod, 2
1
/
4
-inch (57mm)
Servo with hardware (MC35)
3mm x 8mm socket head screw
(4)
Aluminum wheel collar with
setscrew, 3.5mm
Aluminum wheel spacer, 3.5mm
Wheel, 1
3
/
4
-inch (44.5mm)
Wheel axle adapter set
Required Tools and Adhesives
Pliers
Phillips screwdriver: #1
Side cutter
Hobby knife with #11 blade
Clear tape
Threadlock
Hex wrench: 1.5mm, 2.5mm
1. Use a #1 Phillips screwdriver to remove the four 2mm x 8mm self-
tapping screws that secure the nose gear cover to the fuselage. Set the
cover and screws aside until later in the section of the manual.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...