48
EN
7. Route the lead for the retracts through the fuselage. Routing it
through the tray the nose gear is mounted to and along the bottom of the
fuselage will keep the installation clean. Secure any loose leads with tie
wraps (not included).
E-tips
Use a #1 Phillips screwdriver to remove the nose gear cover so there
is better access for routing the retract leads. Replace after routing the
leads.
Motor Battery InstallatIon
Required Parts
Fuselage assembly
Hook and loop tape
Motor battery
Hook and loop strap
Fan cover
Required Tools and Adhesives
Scissors
Phillips screwdriver: #1
1. Apply the hook and loop tape to the bottom of the battery. This will keep
the battery from sliding in the fuselage which could change the center of
gravity.
2. Apply the mating hook and loop tape to the battery tray in the
fuselage.
3. Secure the battery in the fuselage using the hook and loop strap.
Make sure the strap is not pinching any of the servo leads on the bottom
side of the battery tray.
canoPy asseMBly
Required Parts
Canopy
Cockpit interior
Pilot (optional) (PKZ4414)
Required Tools and Adhesives
Hobby scissors
Clear tape
1. Locate the cockpit interior and use hobby scissors to trim the interior
along the inscribed line. Trim the interior a little outside the line so it can
be trimmed to fit to the canopy.
2. Place the interior in the canopy. It may be necessary to bend the
interior slightly to fit past the canopy frame.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...