10
EN
17. Use four 2mm x 8mm self-tapping screws and a #1 Phillips
screwdriver to secure the aileron servo cover to the wing.
18. Use a hobby knife with a #11 blade to trim two 1/4-inch (6mm)
pieces from the silicone tubing.
E-tips
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
19. Assemble the aileron linkage using the two pieces of tubing
from the previous step, two 2mm nuts, two metal clevises and the 2mm x
25mm threaded rod. The length of the rod will be adjusted in the following
steps.
20. Remove the tape holding the flap and aileron in position. Use
the radio system to center the aileron servo. Connect the metal clevis
to the inner hole of aileron servo horn. The remaining clevis connects to
the aileron control horn. Adjust the length of the linkage so the aileron is
centered when the servo is centered. Once the length of the linkage has
been adjusted, slide the tubing over the forks of the clevises to keep them
from accidentally opening in flight. Use needle nose pliers to tighten the
nuts against the metal clevises.
21. Repeat steps 4 through 20 to install the remaining aileron servo
and linkage.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...
