40
EN
13. Remove the tape that holds the elevator to the stabilizer. Connect
the clevis to the elevator control horn. Adjust the clevises so the elevator is
centered when the elevator servo is centered using the radio system. Use
pliers to tighten the 2mm nuts against the clevises and slide the silicone
tubing over the forks of the clevis to prevent the clevis from opening
accidentally in flight.
E-tips
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
14. Repeat steps 3 through 13 to install the remaining elevator servo
and linkage. The pushrod support brace will be assembled using the base
and R1 and R2 standoffs as shown in the following photos. R2 will be
positioned so it is near the hole closest to the edge of the base.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...