46
EN
6-channel receIver assIgnMents
Throttle Speed Control
Aileron Ailerons (harness from step 1)
Elevator Elevator (Y-harness)
Rudder Rudder and Nose Gear Steering (Y-Harness)
Gear Gear (optional) (harness from step 4)
Aux 1 Flaps (harness from step 2)
E-tips
Programs for the Habu using the DX8 are available for download on the
Spektum website.
6. Use scissors to cut a small piece of hook and loop tape. Use the tape
to secure the receiver in the fuselage.
7. Use scissors to cut a small piece of hook and loop tape. Use the tape
to secure the remote receiver in the fuselage.
8. Route the lead for the retracts through the fuselage. Use a pair
of hemostats to hold the leads from the motor while you are plugging
the leads from the controller into them. Routing it through the tray
the nose gear is mounted to and along the bottom of the fuselage will
keep the installation clean. Secure any loose leads with tie wraps (not
included).
E-tips
Use a #1 Phillips screwdriver to remove the nose gear cover so there is
better access for routing the retract leads.
8-channel receIver InstallatIon
Required Parts
Fuselage assembly
Harness from retract assembly
6-inch (152mm) Y-harness
3-inch (76mm) servo extension
(flaps)
6-inch (152mm) servo extension
(retracts)
9-inch (228mm) servo extension
(retracts)
12-inch (304mm) servo extension
(flaps)
18-inch (457mm) servo extension
(2) (ailerons)
Required Tools and Adhesives
Scissors
String
NOTE:
The following section covers the installation of a 7- or 8-channel
receiver. This allows you to optimize and fine-tune the feel of the Habu 32
by using separate aileron channels and also a separate channel for the
nose gear steering. It also allows you to set the nose gear up for separate
trimming and a high and low rate switch.
1. Prepare the flap harness by securing a 12-inch (304mm) extension
to a 6-inch (152mm) Y-harness using string or a commercially available
connector. The 12-inch (304mm) extension will plug into the aileron
channel of the receiver. Secure a 3-inch (76mm) extension to one side of
the Y-harness using string or a commercially available connector. Make
sure to mark the flap harness so it can be easily identified from outside
the fuselage when installing the wing panels.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...