23
EN
15. With the flap lowered, rest a square against the flap hinge line.
Look down on the axle and check that it is perpendicular to the square
as shown. If not, it may be necessary to lightly file the flat areas on the
landing gear wire to correct for any misalignment.
16. Use a flat file to make a 1/4-inch (6mm) wide flat area on the
gear near the end of the axle strut for the setscrew to rest. This will keep
the wheel collar from vibrating loose in flight.
E-tips
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
17. Slide a 3.5mm aluminum wheel spacer on the axle, then the
wheel with adapters. A 3.5mm wheel collar is used to secure the wheel
in position by tightening the setscrews onto the axle using a 1.5mm hex
wrench.
E-tips
The end of the axles may have a slight bur on them from the factory. If
the wheel is hard to install use a file to remove this bur.
18. Check to make sure the axle is flush with the edge of the outer
wheel collar. If not, use a rotary tool and cutoff wheel to trim the axle
flush with the wheel collar. Make sure to remove the wheel so the heat
generated from the cutting does not melt the bushings in the wheel.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...
