8
EN
5. Use a pencil to draw two lines on the cover. The first line is along
the bottom of the cover, 3/32-inch (2.5mm) from the edge. The second line
is 7/8-inch (22mm) from the side of the cover as shown. This will center
the servo horn in the slot when using the recommended servos.
6. Sand the 10mm x 7mm end of the block using medium grit
sandpaper. This will be the end glued to the plate in the next step.
7. Use 5-minute epoxy to glue the 13mm x 10mm x 7mm hardwood
block to the servo cover. Make sure to glue the 10mm x 7mm end to the
surface of the plate. Allow the epoxy to fully cure before proceeding.
8. Use a rotary tool and small sanding drum to make a notch in the
block for the servo lead. Check the fit of the servo to make sure the servo
lead can clear the mounting block.
9. Position the aileron servo with the grommets resting on the first
mounting block and the servo parallel to the line on the cover. Use a pencil
to mark the location for the remaining servo mounting block.
10. Use 5-minute epoxy to glue the remaining block to the cover.
Don’t forget to roughen the end of the block as shown in step 6.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...