44
EN
4. Use clear tape to secure the thrust tube to the fan housing.
5. Use clear tape at the bottom of the thrust tube to secure the
tube at the rear of the fuselage.
6. Route the leads from the motor through the oval opening at the
bottom of the former near the intake ducts. Use clear tape to tape the
leads to the fan housing and intake duct so they don’t move and interfere
with the operation of the elevator servos.
7. Cut a piece of hook and loop tape to fit the back of the speed control
using scissors. Apply the tape to the speed control as shown.
E-tips
Matching the colors between the ESC and motor when they are connect-
ed results in the correct motor direction if using all E-flite components.
8. Connect the leads from the speed control to the leads from the
motor. Use a pair of hemostats to hold the leads from the motor while you
are plugging the leads from the controller into them.
9. Remove the backing from the hook and loop tape to mount the
speed control inside the fuselage. Make sure to secure the switch inside
the fuselage where it can be easily accessed using double-dated tape.
E-tips
Make sure to set the cutoff voltage of the speed control to match the cell
count of the battery.
Summary of Contents for Habu 32 EDF ARF
Page 1: ...Instruction Manual Bedienungsanleitung ...
Page 107: ...107 DE ...