Dynapac Svedala Demag EB 34 Series, Operation & Maintenance Manual

Page: 64 / 90

E 8
E_EB3
4_VB340
__05.
08_G
B.
fm
-14 02-
05.
08
3.6 Fitting extension parts
m
The screw-on surface must be clean and, if the screed is already being used, must
be free of any bitumen residue.
This applies in particular to the base plate joints.
- Guide extension part and extendable
part together on a level support face.
The tamper drive shaft must be se-
cured (unable to rotate) during this
process.
- Slide the drive shaft coupling half
through the relevant hole in the screed
body of the extendable part with the in-
serted plastic star and place on the
second coupling half located there.
- Abut the extension part and extenda-
ble part against one another.
- Gently tighten retaining bolts (1).
- Set height of extension part:
- Loosen lock nut (2).
- Use adjustment screw (3) to set the
correct height for the extendable
part.
- Tighten lock nut (2)
- Securely tighten retaining bolts (1)
3.7 Fitting side shield to extension part
A
Refer to Section 2.2
Gas340.wmf/Anbau_340.jpg
1
2
3