Dynapac Svedala Demag EB 34 Series, Operation & Maintenance Manual

Page: 63 / 90

E 7
E_EB3
4_VB340
__05.
08_G
B.
fm
-14 02-
05.
08
3.2 Preparing extension parts
If the screed is equipped with a tamper, to drive the tamper, the tamper shaft must be
fitted before fitting the extension part. The following steps are needed for this:
3.3 Removing tamper deflector plate
- Unfasten two nuts (1) from track rod
by unscrewing them several turns.
- Remove both retaining bolts (2) from
tamper deflector plate.
- Take off tamper deflector plate (3).
3.4 Assembly of tamper drive shaft
- Insert shaft (4) in relevant recess (5) of
screed body.
- Slide both parts of driver coupling (6)
onto one another with the inserted
plastic star.
3.5 Fitting tamper deflector plate
- Insert the rail located inside the deflec-
tor plates (3) into the grooves (7) of the
tightening rods
- Fit both retaining bolts (2) of tamper
deflector plates.
- Tighten both nuts (1) of track rods until stop is reached. To do this, the deflector
plate is tightened before the tamper.
A
The extension part is now prepared and ready to be fitted on the extendable part.
Leitblech_340.wmf
1
2 3
Stampferwelle_340.wmf
5
6
7
4