Dynapac CS1400, Instruction Manual

Page: 42 / 118

Machine description
4812162501_F.pdf 2018-04-25
No Designation Symbol Function No Designation Symbol Function
28 Browse in error codes Turn off / on the ignition.
Turn the switch to the right to show the error code on the
display and the engine warning light starts flashing.
On the warning light shows error codes through various
intervals of blinking.
Short-long-short flashes indicates the error code is. 28 Browse in error codes Turn off / on the ignition.
Turn the switch to the right to show the error code on the
display and the engine warning light starts flashing.
On the warning light shows error codes through various
intervals of blinking.
Short-long-short flashes indicates the error code is.
29 Glowing Lights up when preheating of diesel engine is in
progress and starter switch is in position I. 29 Glowing Lights up when preheating of diesel engine is in
progress and starter switch is in position I.
30 Electronic speed control Controls speed of diesel engine. Low (900 rpm), Medium
(1500 rpm), High (2200 rpm). 30 Electronic speed control Controls speed of diesel engine. Low (900 rpm), Medium
(1500 rpm), High (2200 rpm).
31 Warning lamp, coolant level /
temperature See point 5. 31 Warning lamp, coolant level /
temperature See point 5.
32 Asphalt temperature gauge, switch
(option) The temperature is read at the instrument on the
instrument panel. 32 Asphalt temperature gauge, switch
(option) The temperature is read at the instrument on the
instrument panel.
Warning indication - Electronic engine control Warning indication - Electronic engine control
Status is shown with the warning lamp. Status is shown with the warning lamp.
The system monitors both engine status and itself.
The system monitors both engine status and itself.
Function check Function check
- Ignition on, the warning lamp lights for approx. 2 sec. and then goes out. - Ignition on, the warning lamp lights for approx. 2 sec. and then goes out.
The warning lamp does not light The warning lamp does not light
- In connection with the lamp test, a lamp that goes out indicates that the system is working. - In connection with the lamp test, a lamp that goes out indicates that the system is working.
The warning lamp lights with a continuous red glow The warning lamp lights with a continuous red glow
- Fault in the system - Fault in the system
- The work can continue, but with limitations in the system. - The work can continue, but with limitations in the system.
- A representative from DEUTZ must check the engine. - A representative from DEUTZ must check the engine.
- If the lamp shines continuously, the monitored unit (e.g. coolant temperature, oil pressure)
is below/above the permitted value range. - If the lamp shines continuously, the monitored unit (e.g. coolant temperature, oil pressure)
is below/above the permitted value range.
Depending on the fault in question, the engine output may be reduced to protect the
engine.
Depending on the fault in question, the engine output may be reduced to protect the
engine.
The warning lamp flashes red The warning lamp flashes red
- Serious fault in the system - Serious fault in the system
- Stop the engine immediately. - Stop the engine immediately.
- After an engine stop, the start inhibitor may be activated - After an engine stop, the start inhibitor may be activated
- The start inhibitor is deactivated by turning off the system with the ignition key for approx.
30 sec. - The start inhibitor is deactivated by turning off the system with the ignition key for approx.
30 sec.
- Additional control lamps for e.g. oil pressure or oil temperature may light - Additional control lamps for e.g. oil pressure or oil temperature may light
When braking, engine braking carefully.
Use the brake only in emergency cases, as there is a risk for engine overspeed. When braking, engine braking carefully.
Use the brake only in emergency cases, as there is a risk for engine overspeed.
32