Dynapac CS1400, Instruction Manual

Page: 84 / 118

Maintenance, 10h
4812162501_F.pdf 2018-04-25
Sprinkler system - Check/Cleaning
Fig. Sprinkler ramp
1. Water nozzle
1
Start the sprinkler system and make sure that no
nozzle (1) is clogged. Clean the nozzle and the
roughing filter located by the water pump (2) if
necessary see fig. below.
2
3
Fig. Nozzle
1. Sleeve
2. Nozzle
3. Seal
4. Fine filter
1
4
Sprinkler system/Drum
Cleaning
Dismantle the blocked nozzle by hand.
Blow the nozzle (2) and fine filter (4) clean using
compressed air. Alternatively, fit replacement parts
and clean the blocked parts at a later point in time.
After inspecting and carrying out any necessary
cleaning, start the system and check that it works.
Wear protective goggles when working with
compressed air. Wear protective goggles when working with
compressed air.
74