Dynapac CS1400, Instruction Manual

Page: 111 / 118

Maintenance - 2000h
4812162501_F.pdf 2018-04-25
Hydraulic fluid filter - Replacement
Fig. Hydraulic fluid filter
1. Fluid filter
1
The filter is located on the left side of the frame.
Clean thoroughly around the oil filter.
Remove the oil filter (1) and discard it in a safe
manner. The filter is of the expendable type and
cannot be cleaned. Remove the oil filter (1) and discard it in a safe
manner. The filter is of the expendable type and
cannot be cleaned.
Make sure that the old sealing ring is not left on
the filter holder, as this could cause leakage
between the new and old gaskets. Make sure that the old sealing ring is not left on
the filter holder, as this could cause leakage
between the new and old gaskets.
Thoroughly clean the sealing surface of the filter
holder.
Apply a thin coat of fresh hydraulic fluid on the rubber
gasket of the new filter. Screw on the filter by hand.
Fig. Hydraulic reservoir
3. Sight glass, hydraulic fluid
3
First screw on until the filter seal lies against the
filter holder. Then screw a further half turn. Do not
tighten the filter too hard as this could damage
the gasket. First screw on until the filter seal lies against the
filter holder. Then screw a further half turn. Do not
tighten the filter too hard as this could damage
the gasket.
Start the engine and check that the filter does not leak.
Check the hydraulic fluid level in the sight glass (3)
and top off as required.
Make sure that ventilation (extraction) is adequate
if the engine is run indoors. Risk of carbon
monoxide poisoning. Make sure that ventilation (extraction) is adequate
if the engine is run indoors. Risk of carbon
monoxide poisoning.
101